Ikegami HDL-45E Operation Manual page 58

5 - 30 5. OPERATION
■ BARS MODE
When the MENU select switch is pressed on the item to be set, the value on the right blinks.
Keeping this state, turn the MENU select switch to select the desired value and press it.
BARS TYPE
ARIB BARS TYPE : Sets the White level of the ARIB bar as shown in the right figure.
Notice
■ REMOTE ENG MENU
Sets how to open the engineer menu from the remote controller.
• OFF : Standard mode. The engineer menu cannot be opened from the remote controller.
• ON : Opens the engineer menu from the remote controller.
Notice
■ PRESET FILE LOAD
It is used to return to the factory setup data or the data saved by "ENGINEER SET FILE RENEW" in the engineer menu.
FILE SELECT
LOAD START
BARS MODE
QUIT
BARS TYPE FULL
ARIB BARS TYPE 75%
: Sets the type of the color bar.
ARIB : Association of Radio Industries and Businesses
Once the REMOTE ENG MENU is turned on, it cannot be turned
off until the camera menu operation is completed. It returns to be
turned off when the camera menu operation is completed.
PRESET FILE LOAD
QUIT
FILE SELECT FACTORY
LOAD START START
PUSH SET → START
: Selects the data to load.
FACTORY : Selects the factory setup data.
ENGINEER : Selects the data saved by ENGINEER SET FILE
: Starts to load data.
When START is selected after READY, PUSH SET→START is
displayed. When loading, select START again. When discontinuing,
select CANCEL or close the menu with QUIT.
(FULL, ARIB)
(100%, 75%, +I)
(FACTORY, ENGINEER)
(READY, START, CANCEL)
When START is selected, it is displayed.
RENEW.
FULL
ARIB
White 100% ,
White 75% ,
+I