Ikegami HDL-45E Operation Manual page 51

■ AUTO DPC
QUIT
DPC
DETECT MODE
SAMPLE AREA SET
AUTO DPC
DPC EFFECT CHK
DPC CLEAR
DPC
DETECT MODE
SAMPLE AREA SET : Sets defect correction range.
AUTO DPC
DPC EFFECT CHK
DPC CLEAR
[Correction]
1. On "MENU PAGE4," select "AUTO DPC" and press the MENU switch. The sub menu of "AUTO DPC" is displayed.
2. Verify that "DPC" is set to "ON." If it is set to "OFF," turn the MENU switch to set the blinking cursor to "DPC" and press
it. The blinking cursor moves to the mode. Then, turn the MENU switch to select "ON" and press it.
3. Select a "DETECT MODE" according to the type of defective pixels to be corrected.
Notice
To detect defective black pixels, a white subject such as a pattern box where overall
screen is evenly illuminated is required. To avoid malfunctions, do not perform
defective black pixel detection for a normal subject.
4. Turn the MENU switch to select "SAMPLE AREA SET" and press it. The blinking cursor moves to the mode. The
WINDOW cursor (□) is displayed on the screen.
5. Turn the MENU switch to move the WINDOW cursor (□) to the right or left (horizontally). Press the MENU switch at the
point to be corrected. Then, turn the MENU switch to move the WINDOW cursor (□) up and down (vertically). Press the
MENU switch at the point to be corrected. If the MENU switch is pressed when the WINDOW cursor is at an improper
position, turn the MENU switch again to select "SAMPLE AREA SET" and press it.
6. Turn the MENU switch to set the blinking cursor to "AUTO DPC" and press it. "PUSH SET → START" is displayed on the
lower side of the screen.
7. Press the MENU switch again to correct CCD pixel.
8. When the defect correction is successfully completed, "COMPLETED" is displayed, and a few seconds later, "DPC DATA:
OK" is displayed on the screen. When the defect correction fails, "ERROR" is displayed, and a few seconds later, "DPC
DATA: RETRY" is displayed on the screen.
AUTO DPC
ON
WHT+BLK
OK
OK
: ON: Sets defect correction to on.
OFF: Sets defect correction to off.
: WHITE: Detects defective white pixels.
BLACK: Detects defective black pixels.
WHT+BLK: Detects defective white and black pixels.
: Performs automatic detection and correction of defects.
: ON: Verifies defect correction state in the set range.
CANCEL: Cancels verification of defect correction state.
: OK: Deletes all defect correction data.
CANCEL: Cancels deletion of defect correction data.
5. OPERATION
(OFF, ON)
(WHITE, BLACK, WHT+BLK)
(OK, CANCEL)
(OK, CANCEL)
5 - 23