Grease Replenishment/Exchange For E-Axis Speed Reducer; Grease Replenishment - YASKAWA MOTOMAN-VA1400 Instructions Manual

155556-1CD
VA1400

9.3.3 Grease Replenishment/Exchange for E-Axis Speed Reducer

9.3.3.1 Grease Replenishment

9 Maintenance and Inspection
9.3 Notes on Grease Replenishment/Exchange Procedures
Fig. 9-6: E-Axis Speed Reducer Diagram
E-axis speed reducer
For the ceiling-mounted manipulator, the grease exhaust
NOTE
port and the grease inlet are inverted.
(Refer to Fig. 9-6 "E-Axis Speed Reducer Diagram".)
1. Remove the hexagon socket head plug PT1/8 from grease exhaust
port.
2. Remove the hexagon socket head plug PT1/8 from the grease inlet.
• If grease is injected with the plug on, the grease will leak
inside the motor and may cause a damage. Make sure to
remove the plug before the grease injection.
NOTE
• Do not install a joint, a hose, etc. to the grease exhaust
port. Failure to observe this instruction may result in
damage to the motor due to coming off of an oil seal.
3. Install a grease zerk PT1/8 to the grease inlet. (The grease zerk is
delivered with the manipulator.)
4. Inject grease througn the grease inlet using a grease gun.
– Grease type:
– Amount of grease:
– Air supply pressure of grease pump:
– Grease injection rate:
5. Move the E-axis for a few minutes to discharge excess grease.
6. Remove the grease zerk from the grease inlet, and reinstall the plug.
Before installing the plug, apply Three Bond 1206C on the thread part
of the plug, then tighten the plug with a tightening torque of 4.9 N•m
(0.5 kgf•m).
9-12
Grease exhaust port
Hexagon socket head
plug PT 1/8
Grease inlet
Hexagon socket head
plug PT 1/8
VIGO Grease RE No. 0
45 cc (90 cc for 1st supply)
0.3 MPa or less
8 g/s or less
HW0484963
57 of 85