Permobil F5 Corpus Service Manual page 86

F5 Corpus
5. Connect the AP elevator cabling to the ICS master module. It
should be connected to either one of the connectors J11 or J12.
6. Mount the seat. See 4.1.1 Seat , Page 18.
7. Mount the AP elevator rod to the back rest hinge. It is attached with
a pin and circlip.
8. Connect the Tilt motor cabling to the contact block at the seat
frame. Mount the cable to its cable brackets on the right hand side
of the seat. See 4.2.2.4 AP elevator tilt motor cable , Page 112.
9. Check your documentation of the cable set up.
10. Connect the R-net cables to the contact block at the back of the
backrest. Assemble the cables to its cable brackets. See 4.3.2 R-net
and ICS bus cabling , Page 157.
86
Repairs - Chassis
Figure 242. ICS master module.
Figure 243. The AP elevator rod is attached with a pin
and circlip.
Figure 244. The Tilt motor cabling is attached to the
contact block on the seat frame.
Figure 245. Connect the R-net cable from the contact
block at back of the backrest.