Permobil F5 Corpus Service Manual page 100

F5 Corpus
CAUTION!
Always replace the textile cover
The textile cover should always be replaced when the actuator is replaced.
27.
Depending on the revision of the carriage there are different
actions.
Carriage A: Remove the nut and the M6 screw and scrap them,
remove the locking plate (A) and save it for later installation. If the
M5 screw and textile cover is present remove and scrap them.
Carriage B: Remove the M5 screw for the locking plate and scrap
it, remove the locking plate (A) and save it for later installation. If
the M5 screws and textile cover is present remove and scrap them.
28. Gradually loosen the strap that goes around the leg rest and the AP
elevator shaft while unscrewing the plastic nut.
29. Remove the actuator.
100
Repairs - Chassis
Figure 289. The carriage A with the M6 screw and nut.
Figure 290. The carriage B with the M5 screws.
Figure 291. The plastic nut is located in the carriage.
The white striped areas marks a cut through parts for
better visuals.
Figure 292. The top plate without the seat for better
visuals.
A
A