F5 Corpus
37.
This step is only necessary if the textile cover is in separate parts.
Assemble the plate to the textile cover.
NOTICE
Snap the plastic bearing in place
Make sure that the plastic bearing snaps in place properly into the bracket.
38. Mount the plastic bearing into the bracket. Apply grease (Molykote
PG-75 or equal lubricant compatible with plastic and elastomer) on
the inside of the bearing. The bracket can look different depending
on the revision. See A or B.
39. Slide the textile tube onto the actuator spindle. Make sure that the
seam of the cover is facing the top plate's underside.
Repairs - Chassis
Figure 301. Pull one end of the plate thru one of the
holes.
Figure 302. Pull the other end of the plate thru the
opposite hole.
Figure 303. Apply grease on the inside of the bearing.
Figure 304. Underside of the top plate.
103