Support Wheel Unit - Permobil F5 Corpus Service Manual

F5 Corpus
This step does only apply if the wheelchair is equipped with an early
revision of the friction brake (see Figure 424).
3. Attach the nut, washer, adjustment unit, o-ring, friction brake screw
and friction brake plate.
For the adjustment see: 5.2.1 Friction brakes , Page 185.
CAUTION!
Be careful with the O-ring
Do not damage the O-ring. It will affect the maneuverability of the wheelchair.
This step does only apply if the wheelchair is equipped with a later
revision of the friction brake.
4. Install the screw. Screw the friction brake in place while holding the
wheel fork. Tightening torque: 17.7 lb.ft.
5. Install the cover on top of the swing arm.
Install the cover on top of the link arm.
4.2.8

Support wheel unit

For this task the following tools are necessary:
• 1 Torque wrench.
• 1 Allen key socket 6 mm.
Repairs - Chassis
Figure 424. An early revision of the friction brake.
Figure 425. Push the cover into place.
141