Permobil F5 Corpus Service Manual page 153

F5 Corpus
4.2.14.2 Front turn signals
Removing front turn signal
1. Switch off the power supply using the On/Off key on the control
panel and switch the main circuit breaker to Off. See
4.3.5 Main circuit breaker , Page 165.
2. Remove the drive package covers including the front fender. See
Removing drive motor cover , Page 73. Disconnect the lights and
indicators at the connectors on the cables.
3. Disconnect the two cables on the back of the indicator by pulling
them straight out.
4. The indicators are assembled on the cover with double sided tape.
Carefully peel the indicator in question off, if needed use a suitable
tool to facilitate removal. Be careful not to damage the paint work
on the cover.
5. To remove the cables, remove the tape that holds the cables to the
cover.
Mounting front turn signal
1. Remove the protective tape on the back of the indicator.
2. Rotate the indicator until the text "TOP" is pointing straight
upwards and position the indicator on the drive package cover. Press
it against the cover until the double sided tape sticks on to the cover.
3. Connect the two cables on the back of the indicator.
4. If removed, fit the cables with a tape on the inside of the cover. See
fig. 458.
5. Connect the indicator cables to the front light and to the lights main
cable in the chassis. See Mounting drive motor cover , Page 75.
6. Fit the covers. See 4.2.1 Covers .
4.2.14.3 Front lights
For this task the following tools are necessary:
• 1 Allen key 2,5 mm.
Repairs - Chassis
Figure 458. The front turn signal is assembled on the
drive package cover.
Figure 459. Remove the protective tape and rotate the
indicator until the text "TOP" is pointing straight
upwards.
153