Permobil F5 Corpus Service Manual page 75

F5 Corpus
5. On wheelchairs with lights only (no indicators), position the adapter
cable between the drive motor and gear and through the slot on top
of the cover.
Mounting drive motor cover
The drive motor cover is assembled with a knob (3) on the top and
hook and loop fasteners (4) on the side and a fixing point (5) at the
bottom.
1. Position the drive motor cover on the fixing point at the lower edge
of the drive gear.
2. Position the cover on the drive package making sure the fixing
point (5) is correct positioned with the screw head (6) in
corresponding hole of the cover.
3. Make sure it fits towards the drive gear cover and assemble the knob
(3) on the top.
4. Press the cover from the side against the drive package until the
hook and loop fastener (4) attaches with a "Click".
Mounting front fender
The front fender is assembled with a screw (1) and two fixing points (2).
The wheelchair is shown without the drive wheel to get a better view
of the front fender. The drive wheel does NOT need to be removed for
this operation.
1. Position the front fender making sure the two fixing points (2) are
correctly positioned in the grooves on the fender.
2. Assemble the screw (1) and washer. The front fender and the drive
motor cover should be attached in a groove (3).
3. Position the drive motor cover making sure the two fixing points
are correctly positioned in the grooves on the fender.
Repairs - Chassis
Figure 204. On wheelchairs with lights only (no
indicators), position the adapter cable between the
drive motor and gear and through the slot on top of the
cover.
Figure 205. The drive motor cover is assembled with
hook and loop fasteners (3 – 4) and a fixing point (5) at
the bottom.
Figure 206. The front fender is fitted with one screw (1)
and two fixing points (2) at the bottom.
75