Permobil F5 Corpus Service Manual page 156

F5 Corpus
2. Remove the cable ties holding the R-net control panel (A) and the
ICS control panel (B) cabling in place under the arm rest. Note the
attachment locations of the cable ties for subsequent reassembly.
Same attachment points must be used.
3. Disconnect the R-net control panel (A) cable connector.
4. Remove the R-net control panel (A). It is held in place by two
screws. The same two screws also fasten the bracket for the ICS
control panel (B), where fitted.
4.3.1.2 Mounting R-net control panel
1. Assemble the R-net control panel (A). It is held in place by two
screws. The same two screws also fasten the bracket for the ICS
control panel (B). Be sure not to over tighten the screw.
2. Reconnect the R-net control panel cable connector.
3. Use cable ties to secure the cabling from the R-net control panel
(A) and the ICS control panel (B). Use the same mounting points
for the cable ties that were used before the cables were disassembled.
156
Repairs - Control panel and electronics
Figure 466. The control panel is held in place by two
screws on the rotational panel holder.
A
Figure 467. The control panel is held in place by two
screws on the parallel panel holder.
Figure 468. The control panel is held in place by two
screws on the rotational panel holder.
A
Figure 469. The control panel is held in place by two
screws on the parallel panel holder.
B
B