Permobil F5 Corpus Service Manual page 51

F5 Corpus
4. Remove the front bracket of the manual adjustment unit or
actuator. Start with the lock nut and the washer on the inside of the
bracket, then remove the screw and washer.
5. Remove the leg rest, which is held in place by two screws and
spacers.
4.1.10.2 Mounting leg rest
1. Assemble the leg rest using the two screws and spacers. Use a torque
wrench to tighten the screws. Tightening torque 17.7 lb.ft.
2. Assemble the front bracket of the manual adjustment unit or
actuator. Start with the screw and washer. Tighten the screw using a
torque wrench. Tightening torque 17.7 lb.ft. Then fit the lock nut
and washer on the inside of the bracket. Hold the screw to
counteract rotation while tightening the nut. Tighten the nut using
a torque wrench. Tightening torque 17.7 lb.ft.
3. Assemble the front ends of the UniTrack rails.
Figure 125. The leg rest is held in place by two screws
and spacers. The front bracket of the actuator is held in
place by a screw and lock nut.
Figure 126. The leg rest is held in place by two screws
and spacers. The front bracket of the actuator is held in
place by a screw and lock nut.
Figure 127. Reassemble the front ends of the UniTrack
rails.
Repairs - Seat
51