Permobil F5 Corpus Service Manual page 53

F5 Corpus
3. Remove the seat cushion.
4. Remove the thigh supports.
5. Remove the seat plates on the right-hand side. See
4.1.2 Seat plates , Page 23.
6. Remove the UniTrack rail from the right side of the seat. See page
4.1.3 UniTrack rails , Page 23.
7. Remove the actuator connector by pushing in the two latches on
the connector and pulling it straight out from the junction box on
the right side of the seat.
Make a note of how the cabling is positioned; this is needed when
you re-attach it later.
8. Loosen the actuator cabling from its fixing points. Pay attention to
how the cable is positioned and strapped; this will help during
reassembly. It is very important that positioning and strapping is
performed the same way during the reassembling.
9. Remove the nut (F) and shim washer (E) from the front fixing
screw (C).
10. Unscrew the front fixing screw (C) and dismount the thick washer
(D), bushing (A in the front) and actuator from the leg rest arm.
11. Unscrew the rear mount screw with its washer (B) and dismount the
actuator from the trunnion (A in the rear).
Figure 130. Actuator cabling, applies to both LINAK
and REAC.
Figure 131. LINAK LA28 leg rest actuator is held in
place by two screw joints, (B) and (C).
Figure 132. REAC leg rest actuator is held in place by
two screw joints, (B) and (C).
Repairs - Seat
F
53