Permobil F5 Corpus Service Manual page 21

F5 Corpus
4.1.1.2 Mounting seat
1. Position the seat on to the AP elevator.
2. Mount the six screws holding the seat. The seat should be mounted
in different hole patterns depending on the seat depth setting.
Front
Seat Depth
position
1
15"
1
16"
3
17"
3
18"
3
19"
20" 3
21" 3
22" 3
3
23"
3. Mount the parallel armrest pad to the backrest hinge. It is attached
with a pin and circlip.
4. Check your documentation of the cable set up.
5. Connect the R-net cables to the contact block at the back of the
backrest. Assemble the cables to its cable brackets. See 4.3.2 R-net
and ICS bus cabling , Page 157.
Rear Front
position extension
1 0
2 0
3 +50
4 +50
5 +50
6 +50
7 +50
7
+75
7 +100
Rear
extension
Figure 19. The different mounting positions.
-100
-75
-100
-75
-50
-25
0
0
0
Figure 20. The seat is mounted with six screws.
Figure 21. The parallel armrest rod is attached with a
pin and circlip.
Figure 22. Connect the R-net cable from the contact
block at back of the backrest.
Repairs - Seat
21