Permobil F5 Corpus Service Manual page 114

F5 Corpus
4. The tilt motor cable is connected to the fifth position of the
connector block at the right hand side of the seat.
4.2.2.5 AP elevator pinch guards
For this task the following tools are necessary:
• 1 Allen key 2,5 mm.
Removing AP elevator pinch guards
1. Raise the seat to its highest position.
2. Switch off the main power switch on the control panel.
3. Remove the four screws holding the pinch guard to the upper arm.
4. Remove the pinch guard.
5. Remove the five screws holding the pinch guard to the lower
elevator arm.
6. Remove the pinch guard from the lower elevator arm.
114
Repairs - Chassis
Figure 342. Tilt motor cable is connected to the fifth
position of the connector block.
Figure 343. On/Off symbol depending on model.
Figure 344. The pinch guard is assembled with four
screws.
Figure 345. The pinch guard is assembled with five
screws.