Ics Master Module - Permobil F5 Corpus Service Manual

F5 Corpus
4.3.3.2 Mounting R-net power module
Assemble in reverse order.
1. Reassemble the power module and battery cable holder, it is fitted
with two nuts. See fig. 486.
2. Reconnect the electrical connections to the R-net controller and
wrap the cable according to fig. 486.
3. Reassemble the chassis covers, see4.2.1 Covers , Page 67.
4. Switch the main circuit breaker to OFF. See
4.3.5 Main circuit breaker , Page 165.
BUS BUS
M1
Motor 1, Left
BATT Battery
M2 Motor 2, Right
INH
Inhibit
OBC
External charger socket
4.3.4

ICS master module

4.3.4.1 Removing ICS master module
1. Switch off the main power switch on the control panel.
2. Switch the main circuit breaker to OFF (OFF). See
4.3.5 Main circuit breaker , Page 165.
3. Remove the front chassis cover. See 4.2.1 Covers , Page 67.
4. Disconnect the electrical connections of the ICS master module,
being attentive to their placement. See fig. 491.
5. Pull the master module straight out of its holder.
6. If the wheelchair is equipped with lights, remove the lid from the
ICS master module and disconnect the lights cabling from the
contacts on the circuit board. See fig. 491.
Repairs - Control panel and electronics
Figure 488. Power module cable connections (R-net
PM120).
Figure 489. On/Off symbol depending on model.
Figure 490. ICS master module.
163