Batteries - Permobil F5 Corpus Service Manual

F5 Corpus
WARNING!
Risk of crushing - two people are required
Two people are required for this task due to heavy lifting. Watch out for
moving parts, there is a risk of crushing.
Removing track wheel kit
1. Raise the seat a bit, stop just before the AP elevator axle touches the
spring unit.
2. Run the leg rest slightly outwards, approximately 30°.
3. Switch off the main power switch on the control panel.
4. Hold the rear end of the seat in a steady grip. Remove the screw (1)
and washers (2 and 3) on both sides.
5. When the screws are removed, the rear end of the seat will come
loose. Tilt the seat slightly forward in order to reveal the axle and all
the parts.
6. Remove the roller (4), the slide bearing (5), the shaft (6), the slide
bearing (7) and the inner roller (8) from each side.
7. Remove the shaft (9).
Mounting track wheel kit
1. Position the shaft (9).
2. Assemble the inner roller (8), the slide bearing (7), the shaft (6), the
slide bearing (5), the roller (4), the washers (3 and 2) and the screw
(1) on to the shaft (9).
3. Tighten the screws (1) using a torque wrench. Tightening torque:
17.7 lb.ft.
4.2.3

Batteries

4.2.3.1 Removing batteries
The following tools are necessary for this task:
• 1 Allen key, 6 mm.
118
Repairs - Chassis
Figure 357. On/Off symbol depending on model.
Figure 358. The track wheel kit.
Figure 359. The track wheel kit.