Permobil F5 Corpus Service Manual page 56

F5 Corpus
3. Remove one end of the leg rest strap by carefully raising the lower
section of the leg rest slightly and at the same time removing the
two screws on the front of the leg rest. Pull the assembling plate out
of the loop of the strap. See fig. 141.
Once the strap is loosened the lower section of the leg rest will
become loose and can be carefully pulled downwards/forwards until
the lower section of the leg rest is completely loose.
4. Remove the slide bushing in the upper section of the leg rest, which
is attached using two screws.
5. Remove the slide bushing in the lower section of the leg rest, and at
the same time use a suitable tool to press in the locking tabs on the
bushing, located in the hole immediately below the top edge of the
leg rest.
4.1.13.2 Mounting leg rest slide bushings
1. Fit the slide bushing in the lower section of the leg rest, making sure
the locking tabs on the bushing are securely fixed in the hole in the
leg rest. See fig. 140.
2. Fit the slide bushing in the upper section of the leg rest using the
two screws. See fig. 139.
3. Slide the upper and lower sections of the leg rest together, and pull
the leg rest strap through the leg rest mechanism.
4. Place the assembling plate in the loop of the strap and then assemble
this on the front of the leg rest using the two screws.
56
Figure 139. The slide bushing in the upper section of
the leg rest is attached using two screws.
Figure 140. Slide bushing in the lower section of the leg
rest.
Figure 141. Strap assembly on the leg rest.
Repairs - Seat