Permobil F5 Corpus Service Manual page 33

F5 Corpus
3. Remove the seat cushion.
4. Remove the thigh supports.
5. Remove the seat plates. See 4.1.2 Seat plates , Page 23.
6. Remove the two screws securing the seat plate brackets on the left
side.
7. Remove the UniTrack and the seat plate brackets as one unit by
pulling it straight out from the left-hand side.
8. Remove the actuator connector by pushing in the two latches on
the connector and pulling it straight out from the junction box on
the right side of the seat. Remove the cable clips then detach the
actuator cabling.
Widen the right-hand side of the seat if the seat width is 17" or
smaller to make it possible to disconnect the connector.
Make a note of how the cabling is positioned; this is needed when
you re-attach it later.
Figure 60. The two seat plate brackets are attached
with two screws.
Figure 61. The brackets can be wedged if you do not
pull out both simultaneously.
Figure 62. Backrest actuator cabling.
Repairs - Seat
33