Manual Backrest Adjustment Unit - Permobil F5 Corpus Service Manual

F5 Corpus
11. Push back the UniTrack rail brackets with the rail onto the seat bars.
12. Mount the two screws securing the two UniTrack rail brackets.
13. Secure the cabling for the actuator in its fixing points. Consider the
arrangement of the cables carefully and make sure there is no risk of
them getting trapped or otherwise damaged.
14. Connect the actuator connector to the junction box on the right
side of the seat. Fit the connector by pushing it straight in at any
point.
15. Assemble the seat plates. See 4.1.2 Seat plates , Page 23.
16. Assemble the thigh supports.
17. Assemble the seat cushion by means of velcro.
4.1.7

Manual backrest adjustment unit

For this task the following tools are necessary:
• 1 Torque wrench.
• 1 Allen key 5 mm.
• 1 Allen key 8 mm.
• 1 Socket 17 mm.
WARNING!
Risk of injury while adjusting backrest
Do not place any weight or load on the backrest while adjusting the backrest.
4.1.7.1 Removing manual backrest adjustment unit
1. Switch off the main power switch on the control panel.
Figure 82. The UniTrack rail brackets is attached with
two screws.
Figure 83. Backrest actuator cabling.
Figure 84. On/Off symbol depending on model.
Repairs - Seat
39