MAINTENANCE WORK ON CHASSIS AND ENGINE
Fork offset (EXC-R SIX DAYS, XCR-W USA)
B
0 0 B
A
0 0 A
x
Setting the fork offset
Removing the fork legs
You can see the currently set offset if you remove screw
The fork offset
the center of the fork leg to the center of the steering head bearing.
The fork offset can optionally be adjusted.
Marking
to the front gives greater stability on fast racetracks.
Fork offset
Front marking
Marking
to the rear (condition at delivery) gives better handling in bends.
Fork offset
Rear marking
0 0 1
1
400188-10
(EXC-R SIX DAYS, XCR-W USA)
Remove the lower triple clamp. (
Remove screw
Clean the parts and check for damage.
Rotate the steering stem 180° and insert into the triple clamp. Mount and tighten
screw
Specification
Screw, bottom steering
head
Install the lower triple clamp. (
500104-10
Remove front wheel. (
Remove screws
Remove cable clip
Hang the brake caliper and the brake line loosely to the side.
500093-10
(EXC-R SIX DAYS, XCR-W USA)
Loosen screw
Loosen screw
500094-10
has an impact on the handling of the vehicle. It is calculated from
18 mm (0.71 in)
20 mm (0.79 in)
P. 43)
. Remove the steering stem.
.
M20x1,5
P. 44)
P. 63)
and take off clamp.
, remove screw
. Remove the fork leg on the left.
. Remove the fork leg on the right.
.
60 Nm
Loctite
(44.3 lbf ft)
and take off the brake caliper.
41
®
243™