Addressing The Sbb-Ri; Connecting To Read Head; Recommended Wire Chart: Sbb-Ri To Reader Head - Vanderbilt lite blue Manual

64 lite blue Installation Manual

Addressing the SBB-RI

W2 on the SBB-RI consists of four jumpers that can be combined to set the address for the device. Each SBB-RI
on a lite blue controller RS-485 data channel must have a unique address (1 – 8).
Make a note of the address of the SBB-RI and which channel it is connected to. This information will be required to
set up the lock in the software.
SBB-RI Address Chart
SBB-RI Address
1
2
3
4
5
6
7
8

Connecting to Read Head

The SBB-RI reader interface can communicate to many different read heads. Provided here are the pin outs for
the most commonly used read-heads. The connection is different for each reader type. See the Recommended
Wire Chart below for the proper wire type and lengths.

Recommended Wire Chart: SBB-RI to Reader Head

Connection
SBB-RI to Magstripe Reader Head
SBB-RI to Proximity Reader Head
SBB-RI to Door Contact
SBB-RI to Exit Button
Abbreviations:

Cond. = Conductor

Strd. = Stranded

Shld. = Shielded
Jumper Locations
1 2 4 8
2 4 8
1 4 8
4 8
1 2 8
2 8
1 8
8
Maximum
Distance (ft)
200
500
2000
2000
Cable Recommendation
22 AWG/5 Cond, Strd, Shld
22 AWG/5 Cond, Strd, Shld
22 AWG/2 Cond, Strd, Shld
22 AWG/2 Cond, Strd, Shld