Log In To Sus; Pair To Pda - Vanderbilt lite blue Manual

102 lite blue Installation Manual
Initial set up of the PIM400 requires the following:

Login to SUS


Pair to PDA


Set PIM400 Address

Log In to SUS

You must log in to the Schlage Utility Software (SUS) located on the included PDA. Follow the steps below to log
in:
Start
1 Click on the PDA. A Menu will open with a list of programs.
Schlage Utility Software
2 Select the
Manager
3 Select
4 Enter the password into the
Login
5 Click the
Connected.
Pair to PDA
The PIM400 must be paired to the PDA the first time it is connected. Follow the steps bellow to pair the PDA to the
PIM400:
1 Log in to SUS (see steps above).
2 Connect the PDA to the PIM400 using the supplied USB cable.
Options
3 Click on the
4 Put the PIM400 into
settings).
a) On the PIM400, hold down the
Link 2 (S3)
b) Press the
in the Schlage button will flash. The lock is now in pairing mode.
5 On the PDA click the
complete.
Note:
You only need to pair the PIM400 to the PDA once. After pairing the PIM400 and PDA will
communicate whenever connected.
option to open
Log on as
from the drop down menu.
Password
field. Default password is
button. The SUS program will open. The bottom of the screen will say
button at the bottom of the PDA screen. A list of options will open.
Pairing Mode
(this is necessary for the PDA to be able to make changes to the PIM's
Link 1 (S2)
button three times while continuing to hold down the Link 1 button. The red LEDs
Pair PDA to Device
SUS
.
123456
button.
option. A pop-up will display when the pairing process is
.
No Device