Connecting To Lite Blue - Vanderbilt lite blue Manual

Chapter 5 VBB-NRI

Connecting to lite blue

There is no direct connection between the VBB-NRI and lite blue. They need to be on the same network and the
proper IP address of the VBB-NRI needs to be entered when setting up the door (see the VBB-NRI IP
Configuration section for details) for them to communicate. In addition, a data surge protector needs to be installed
lite blue
between and the hub or switch. Install the supplied data surge protector (DITEK-DTK-MRJ45C5E) or an
equivalent UL Listed unit. Power is supplied independently from a power supply connecting to P1 on the VBB-NRI.
Data Communication between lite blue and VBB-NRI
lite blue
Ethernet To Network
VLBIM06/15/15 v4.1.0
VBB-NRI
Ethernet to Network
Pin 1 - PWR (Power)
Pin 4 - GND (Ground)
Power Supply
+ (Power)
- (Ground)
81