Configuring Pim - Vanderbilt lite blue Manual

126 lite blue Installation Manual
Advanced
3 Go to the
4 Uncheck the option
OK
5 Click .
6 If there are any problems, restart the CDT application.

Configuring PIM

The next step is defining the PIM address by placing the
1 After the CDT software has been installed, execute
PIM Status
2 For
3 Connect the PIM to the PC using a DB9 female to DB9 male that is connected to the PIM RS232 port.
4 After this connection is made, hold down one of the PIM link switches (SA or SB).
a) Continue to hold the link switch and press the reset button (S3). Do not stop pressing the link switch.
The LED's (CR6 – 10) on the PIM begin flashing, displaying the firmware version of the PIM. When
b)
completed, (CR7 and 10) will continue to flash RED and CR15 will be continue to blink GREEN. At this
point, the PIM will be in the CDT link mode as long as the CDT program on the PC remains running and
connected to the PIM.
c) Release the link switch.
d) On the CDT screen, under PIM Status you should now see the "PIM Connected on Proper Com Port"
message.
5 Using the Addresses tab, set the address of the PIM.
a) If one PIM is being used per channel set the
tab.
Use Java 2x1.4.2-06 for <applet> (requires to start)
, select the proper com port from the drop down menu.
PIM Link Mode
in to
WirelessDemo.html
PIM Addr
to 0.
.
. Follow these instructions.
from the Wireless Demo folder.