Device Capacities; Linking And Addressing Locks To The Pim; Installing The Cdt Software - Vanderbilt lite blue Manual

124 lite blue Installation Manual

Device capacities

PIM-SBB (Legacy) modules

Contact 1 - PIM module

Tamper state - NC
WAPM modules

Relay 1 for the lock
Relay 1 state will be reported back to lite blue

 Contact 1 for REX – Normally Open, Non-supervised
 Contact 2 for DOD – Normally Open, Non-supervised
 Contact 3 for Tamper – NC, Non-supervised
 Contact 4 for Battery – NC, Non-supervised
 Contact 5 for Motor – NC, Non-supervised (Currently not applicable)

Contact 6 for Request to Enter - NC, Non-supervised
WRI

Relay 1 for the lock
Relay 1 state will be reported back to lite blue


Relay 2 for Aux Relay
Relay 2 state will not be reported to the lite blue

 Contact 1 for REX – Normally Open, Non-supervised
 Contact 2 for DOD – Normally Open, Non-supervised
 Contact 3 for Tamper – NC, Non-supervised

Linking and addressing locks to the PIM

Requirements
- PIM CDT RS-232 cable to the serial port on the PC running the CDT program.

Installing the CDT software

CDT Requirements:

Microsoft Windows XP or higher

Microsoft Internet Explorer 5.0 or higher

Sun Java Runtime Environment (tested with JRE version 6 update 12 or lower, automatically loaded on
most computers)
To install the CDT software:
1 go to http://www.wyrelessaccess.com/
2 Go to the Support Icon.
Configuration & Demonstration Tool
3 Click on
4 Download and save CDT executable.
.