Vanderbilt lite blue Manual page 91

90 lite blue Installation Manual
9 Put the AD-300 lock into
lock's settings).
10 Hold down the
11 While holding down the
300 lock. The red LEDs in the Schlage button will flash.
12 On the PDA click the
complete.
Lock Properties
13 Click on the
Edit
14 Click on the
RS485 Address
15 Click on the
16 Using the touch-keyboard, enter in the address of the lock.
17 Click on the
Successfully
OK
18 Either click
19 Make a note of the address, it will be required to set up the lock in the software.
Pairing Mode
Internal Push Button
Internal Push Button
Pair PDA to Device
option.The Lock Properties window will open.
tab.
field. A touch-keyboard will open at the bottom of the screen.
Save
button at the bottom of the screen. After a moment the
pop-up will open.
on the pop-up, or wait a moment and it will close on its own. The lock has been addressed.
(this is necessary for the PDA to be able to make changes to the
on the AD-300 lock.
Tamper Switch (SW1)
, click the
option. A pop-up will display when the pairing process is
three times on the AD-
Properties Saved