Wri400 Configuration; Connecting To Hhd/Coupling/Linking - Vanderbilt lite blue Manual

108 lite blue Installation Manual
Diagnostics
4 Click on the
Select Door
5 Using the
Status
If the section shows
Now, to perform a complete operational test of the AD-400:
1 Present your credential to the AD-400. If the door is functioning correctly the card data will appear in the
Card Data
field.
2 Depress the Internal Lever. If the door is functioning correctly the
3 Depress the External Lever. If the door is functioning correctly the

WRI400 Configuration

Configuration of the WRI400 is accomplished by the SUS while the HHD is connected to the PIM400. After the
PIM400 has been configured you can Link the WRI400 to the PIM400 and address it.

Connecting to HHD/Coupling/Linking

The HHD is used to configure the WRI400. Follow the steps below to connect to the HHD, couple with the HHD,
and Link to the PIM400. For information about the HHD and WRI400 settings, see the Schlage Utility Software
(SUS) User Guide at www.schlage.com/support.
Connecting to the HHD
To connect the HHD to the WRI400:
1 Verify power is connected to the WRI400.
2 Loosen the 4 screws and remove the WRI400 cover. The Power LED should blink when the cover is off.
Demo Mode
option. The
drop down, select the door you wish to test.
OK
, then you have successfully linked the AD-400.
window will open.
Interior image
Exterior image
will show an open door.
will show an open door.