Contacts, Relays, And Pin Functions - Vanderbilt lite blue Manual

92 lite blue Installation Manual

Contacts, Relays, and Pin Functions

A set of input contacts and output relays are provided on the Schlage VIP Lock. The locks can be ordered with
integrated credential readers.
Input Contacts

Request to Exit (REX), normally open, non-supervised

Door Open Detect (DOD), normally open, non-supervised

Latch bolt monitor (LBM), normally closed, non-supervised

Key position, normally closed, non-supervised

Spare
Output Relays

Solenoid for door strike

Red Led Control

Green Led Control

Beeper Control
Credential Reader Technologies

HID Proximity Credential

Magnetic Stripe Credential
- RS-485 termination. This jumper must be removed to enable communication between VIP and lite blue.
JP1
- Power source and communication. Used to connect lite blue to the VIP.
J3
J6
- Not used.
Dip Switches

1-4
- Used for addressing the VIP. See the Addressing the VIP section for details.

5
- Used to choose between Fail Secure and Fail Safe

OFF - Fail Secure (FSE)

ON - Fail Safe (FSA)

6
- Used to choose between magstripe and proximity reader.

OFF - Magstripe Reader

ON - Proximity Reader

7
- Used to set protocol type. To communicate with lite blue this must be switched to ON.

OFF - VIP protocol

ON - 'F' series protocol
Dip Switch 7 MUST be switched to the ON position for the VIP lock to work with lite blue.
Note: