Additional Configuration - Vanderbilt lite blue Manual

Chapter 8 Schlage Adaptable AD-400 Series
14 Press and hold the WRI400's
15 When linking is successful, the RX/TX LED will blink to indicate the quality of the RF link.

Solid green, fast green blinks, or green with very few red blinks = Good link

Solid red or fast red blinks = Poor or no link
Note:
The WRI400 will fail to link if it is not in RF range of the PIM400.

Additional Configuration

Once the WRI400 has been linked and addressed the Heartbeat, Request to Exit, and Door Position Switch
options need to be configured. Follow the steps below to finish the configuration:
Connect the WRI400 to the HHD
1 Using the USB cable, connect the HHD to
2 Start the SUS application.
3 Log into the SUS (default password is 123456).
a short delay.
4 You are now ready to configure the WRI400.
Configure Heartbeat
Device Options
1 Click on
at the bottom of the SUS screen.
Lock Properties
2 Click on
Edit tab
3 Click on the
4 Scroll down to the
VLBIM06/15/15 v4.1.0
LINK
button until the RX/TX LED blinks red and green.
J5
once the connection steps above have been followed and
.
.
Heartbeat
section of the Edit Tab.
on the WRI400.
WRI400
will be displayed at the bottom of the screen after
111
WRI400
is displayed