Table of Contents
Advertisement
Chapter 8: Cabling the Networking Ports
Installing AT-SP10TW Direct Connect Twinax Cables
104
The SFP and SFP+ transceiver ports of the switches support AT-SP10TW
direct connect twinax cables:
Ports 25 to 28 on the AT-x530-28GTXm and AT-x530-28GPXm
Ports 49 to 52 on the AT-x530-52GTXm and AT-x530-52GPXm
The cables are an economical way to add 10 Gbps connections over short
distances. They have SFP+ transceivers on both ends and come in
lengths of 1 and 3 meters.
To install AT-SP10TW cables in the switch, perform the following
procedure:
1. Select a port for the transceiver.
2. Remove the transceiver from its shipping container and store the
packaging material in a safe location.
3. To install the transceiver in a port in the top row, position the
transceiver with the Allied Telesis label facing up. To install the
transceiver in a port in the bottom row, position the transceiver with the
label facing down. Refer to Figure 52.
Advertisement
Table of Contents
