Setting Up Cable Connections To The Detector - Thermo Scientific Corona Veo Operating Manual

5.5.2

Setting Up Cable Connections to the Detector

Charged Aerosol Detectors Corona Veo (RS) Operating Manual
The following connectors and components are provided on the detector
rear panel:
Figure 6: Rear panel of the detector (here: Corona Veo detector)
No. Description
1 Cooling fan
2 Gas exhaust
Allows connection to ventilation.
3 Gas inlet
Allows connection to a gas supply.
Corona Veo only
4
Manual gas regulator knob
Adjustment knob that allows regulating the nebulizer gas pressure
For Corona Veo RS detectors, a plug is installed instead.
5 Rating plate, indicating the serial number, part number, module name, line and
fuse rating, and the manufacturer's address
6 USB (Universal Serial Bus) port ("B" type connector)
Allows connection (USB 1.1 and 2.0 compatible) to other modules in the
system, such as UltiMate 3000 modules, or the computer on which the data
management system is installed, such as the Chromeleon software.
7 I/O connection terminals
2 terminals with TTL inputs and relay outputs that allow connection to external
devices.
For example, between charged aerosol detector and pump to enable direct
communication in case of an operating issue. Certain problems in the charged
aerosol detector cause an automatic stop of the pump flow to prevent a build-
up of excess liquid inside the detector.
5 • Installation
Page 69