Software Operation; Setting Up The Detector In The Software - Thermo Scientific Corona Veo Operating Manual

6 • Operation
6.8

Software Operation

6.8.1

Setting Up the Detector in the Software

Loading the USB Drivers
Page 148
This section describes the basic steps for operating the Corona Veo (RS)
charged aerosol detector with the Chromeleon software. The steps are
slightly different for Chromeleon 7 and Chromeleon 6.8. For additional
information, refer to the Help and documents provided with the
software.
This section describes the basic steps for operating the Corona Veo (RS)
charged aerosol detector with the Chromeleon 7 software. The steps are
identical for the Chromeleon 6.8 software, but the terminology may
differ. For additional information, refer to the Help and documents
provided with the software.
This manual assumes that the Chromeleon software is already installed
on the data system computer and a valid license is available.
TIP In order to start the Chromeleon Instrument Controller, you must log
on under Windows with local administrator privileges, or as a member
of the Windows Chromeleon Operators user group.
1. Turn on the power to the data system computer if it is not yet
already on.
2. Turn on the power to the charged aerosol detector.
Windows will automatically detect the new devices and perform the
USB installation. If Windows fails to detect the devices and launches
a wizard instead, this indicates that you connected the devices to
the computer and turned on the power for the first time before you
installed the Chromeleon software. In this case, cancel the wizard,
install the software, and then repeat the steps.
Charged Aerosol Detectors Corona Veo (RS) Operating Manual