Self-Test Error Codes - Thermo Scientific Corona Veo Operating Manual

8 • Troubleshooting
8.3

Self-Test Error Codes

Follow these steps
Self-test error codes and remedial actions
Self-test
code
1
2
4
Page 212
If a problem is detected during self-test diagnostics upon power-up of
the detector, a self-test error dialog appears on the detector display. The
detector is not ready for analysis.
1. View the self-test results:
a) In the self-test error dialog on the detector display, select the
Review soft key. The first entry for the self-test review appears.
b) Select the (Test Name) to review the results of the entry. Write
down failed self-tests and their error codes.
Navigate through the self-test review using the Next or Last soft
keys.
c) To exit the self-test review, select the Continue soft key.
Pressing the soft key bypasses the self-test results and displays
the Main Menu.
2. Follow the remedial actions for the respective self-test error code.
After each remedial action, turn the detector off and on to perform
self-test diagnostics and check if the remedial action was successful.
The table lists the self-test error codes for the detector and provides
troubleshooting assistance. Each code consists of a code number and
the letter F to denote a failure. The code number is the unique identifier
for the problem.
If you are unable to resolve a problem following the instructions in this
manual, contact Thermo Fisher Scientific Technical Support for
assistance.
Description
The detector failed to reach the maximum
charger test voltage.
An error occurred with the charger voltage
output when the voltage of the corona
charger was turned off.
An error occurred with the corona charger
current at maximum charger test voltage.
Charged Aerosol Detectors Corona Veo (RS) Operating Manual
Remedial Action
Contact Technical Support.