Communication Submenu - Extron electronics IN1804 Series User Manual

Communication Submenu

Figure 28.
The
Communication
media access code (MAC) address, and to configure the IP address, subnet mask, and
gateway address, and DHCP mode.
• Serial Port Baud Rate — Displays the baud rate for the serial RS-232 port (view only).
• MAC Address — Displays the MAC address of the device (view only).
DHCP Mode — When this mode is enabled (
•
other network settings from the DHCP server. The default is
To enable or disable DHCP mode:
1. Select
2. Press the
You can also set the DHCP mode via an SIS commands (see the
commands
Settings Panel
IP Address — Press the
•
Press the
192.168.254.254
Subnet Mask — Press the
•
address. Press the
default is
• Gateway — Press the
Press the
0.0.0.0
Communication Submenu
submenu enables you to view the serial port baud rate and the unit
from the
DHCP Mode Communications
>
and < button to select
on page 77), the PCS software, or the internal web page (see
on page 97).
and buttons to select an octet of the IP address.
 u
>
and < buttons to adjust the value of the selected octet. The default is
.
and
 u
>
and < buttons to adjust the value of the selected octet. The
.
255.255.255.0
and buttons to select an octet of the gateway address.
 u
>
<
and buttons to adjust the value of the selected octet. The default is
.
IN1804 Scaling Presentation Switcher • Operation
), the unit obtains an IP address and
On
.
Off
submenu and press
or and press
On Off Enter
buttons to select an octet of the subnet mask
.
Enter
again.
DHCP mode
Network
42