Extron electronics IN1804 Series User Manual page 86

Command
IP Control Port Commands (continued)
IP Setup (continued)
Set LAN IP address,
subnet mask, and gateway
address
24
NOTE: Setting any values with a CISG command changes the DHCP setting to Off and the Cisg response is followed by
Boot2 response (when in
View all IP settings
Query the number of open
connections
Reboot networking
Set unit name
Set unit name to factory
default
View unit name
KEY:
X1)
= On or off, enable or disable
X8!
= Unit name
X8^
= Number of open connections
X8&
= IP address
X8*
= Gateway address
X8(
= Subnet mask
X9)
= Hardware (MAC) address
X9@
= Default unit name
X9#
= Subnet mask in CISG commands
ASCII Command Response
(Host to Scaler) (Scaler to Host)
E X8& X9# X8* }
1* / * CISG
Cisg 1*
verbose mode 2 or 3).
E } X8&
1CISG *
E } X8^]
CC
Verbose modes 2 and 3:
Icc
E }
2BOOT Boot2
E X8! }
CN Ipn•
E }
•CN Ipn•
E } X8!]
CN
0 = DHCP disabled (default), 1 = DHCP enabled
A text string of up to 32 characters.
• A-Z, 0-9, and the hyphen (–) are permitted.
• The first character must be a letter.
• The last character cannot be a hyphen.
• No distinction is made between uppercase and lowercase letters.
• Space or blank characters are not permitted.
0-<maximum number of open connections>
Format nnn.nnn.nnn.nnn (192.168.254.254 = default)
Leading zeros in each of the four octets are optional in setting values,
and are suppressed in returned values.
nnn.nnn.nnn.nnn (0.0.0.0 = default)
nnn.nnn.nnn.nnn (255.255.255.0 = default)
00-05-A6-xx-xx-xx
Combination of the model name and the last three hexadecimal
character pairs of the unit MAC address.
Example: IN1804-DO-14-9A-B0.
Prefix representing subnet mask bits (subnet mask value in CISG
commands).
Default = /24, which represents the default subnet mask,
255.255.255.0.
IN1804 Scaling Presentation Switcher • SIS Configuration and Control
Additional Description
X8& X9# X8*]
/ *
Set the IP address to
port (1), the subnet mask prefix to /
and the gateway address to
same time.
X9# X8*] View the IP address, subnet mask
/ *
(prefix), and gateway address for the
unit.
View the number of open connections.
X8^]
] Restart the network after IP setting or
DHCP changes.
X8!] Assign a name for the unit.
X9@] Reset the unit name to its factory default
name.
View current unit name
X8&
for the LAN
X9#
,
X8*
at the
X8!
.
78