Extron electronics IN1804 Series User Manual page 63

X5@ = Audio input format
Format
Selection
0 = None (input muted) —Configures input EDID with no audio support. All audio
outputs are muted.
1 = Analog input — Configures input EDID with no audio support. Analog audio
from the 5-pole captive screw input is passed to the 5-pole captive screw
analog output and embedded into the HDMI output.*
2 = LPCM-2Ch — Configures input EDID for LPCM-2Ch support. Passes all digital
audio input signals to the HDMI outputs. If LPCM-2Ch audio is present it is also
de-embedded to the 5-pole captive screw analog output.
3 = Multi-Ch — Configures input EDID for Multi-Ch support. Passes all digital audio
input signals to the HDMI outputs. If LPCM-2Ch audio is present it is also de-
embedded to the 5-pole captive screw analog output.
4 = LPCM-2Ch Auto (default) — Configures input EDID for LPCM-2Ch support.
Passes all digital audio input signals to the HDMI outputs. If LPCM-2Ch audio
is present it is also de-embedded to the analog 5-pole captive screw output.
If no embedded audio is present on the input the IN1804 passes analog audio
from the 5-pole captive screw input.
5 = Multi-Ch Auto — Configures input EDID for Multi-Ch support. Passes all digital
audio input signals to the HDMI outputs. If LPCM-2Ch audio is present it is also
de-embedded to the analog 5-pole captive screw output.
If no embedded audio is present on the input, the IN1804 passes analog audio
from the 5-pole captive screw input.
*On the IN1804 DI, when Input 4 is set to DTP mode, the scaler uses analog audio from
the remote DTP transmitter instead of analog audio from the rear panel of the IN1804.
Analog and Auto formats are not allowed on input 4 of the IN1804 DI when it is set to XTP
mode.
X5$ = Analog audio input gain
NOTE: On IN1804 DI, analog gain adjustment is not available on TP Input 4 (fixed at
0 dB).
X5% = Video signal status
X5& = Remote port number
X5* = Baud rate
X5( = Parity
X6) = Data bits
X6! = Stop bits
IN1804 Scaling Presentation Switcher • SIS Configuration and Control
Details
-18 through +24 dB
0 = default
Response is two digits.
0 = Video, TMDS, or DP signal not detected
1 = Video, TMDS, or DP signal detected
1 = Remote port (3-pole captive screw)
4 = Universal asynchronous receiver-transmitter (UART)
on DTP input 4 (IN1804 DI only)
9 = UART on DTP/HDBT output 1A (IN1804 DO only)
300, 600, 1200, 1800, 2400, 3600, 4800, 7200,
9600 (default), 14400, 19200, 28800, 38400, 57600,
115200
Odd, Even, None (default), Mark, Space
Only the first letter is required.
7 or 8 (default)
1 (default) or 2
55