Network Settings Panel; Rs-232 Panel - Extron electronics IN1804 Series User Manual

Network Settings Panel

In the
Network Settings
address, subnet mask, and gateway address for your IN1804, and turn DHCP on and off.
You can also view the MAC address of the unit. To set the IP addresses:
1. Click
Edit
Settings
Figure 54.
2. Edit the network settings as desired:
DHCP — Click the
•
When DHCP is enabled (
settings from the DHCP server. The default is
IP Address, (
•
of these addresses, click in the desired field and enter the address.
3. When finished editing, click Save to confirm your changes or
window without making changes. You can also close the window by clicking the
upper-right corner of the screen.
NOTE: If DHCP is being enabled, the webpage attempts to redirect and connect to
the unit via the unit name (TCP/IP hostname). If a static IP address is being set, the
webpage attempts to connect to the new IP address.

RS-232 Panel

The view-only RS-232 panel (see
IN1804 serial port. The defaults are:
• Baud rate —
• Parity Bit —
• Data bits —
Stop bits —
•
figure
panel (see
in the lower-left corner of the
screen opens.
Edit Network Settings Screen
button (see figure 54,
DHCP
), the unit configures its IP address and other network
On
), Subnet mask (
2
figure 46,
9600
(none)
N
8
1
IN1804 Scaling Presentation Switcher • Internal Web Pages
46,
, on page 91), you can set the IP
7
panel. The
Network Settings
) to toggle DHCP on and off.
1
.
Off
), and Gateway address (
3
Cancel
) displays the RS-232 protocol for the
8
EDIT Network
) — To set any
4
to close the
in the
X
97