Extron electronics IN1804 Series User Manual page 83

Command
Resets
System reset (soft reset)
Absolute system reset
Absolute system reset, retain
IP settings
Serial Port Configuration
Set serial port parameters
View the serial port
parameters
Set UART start point
View UART start point
NOTE: The remote power state for HDBT/XTP mode is forced to Off (0). Attempts to change the power setting while the
unit is not in DTP mode result in an E14 (Not valid for current configuration) error message.
KEY:
X5&
= Remote port number
X5*
= Baud rate of port
X5(
= Parity
X6)
= Data bits
X6!
= Stop bits
X6%
= UART port start point
ASCII Command Response
(Host to Scaler) (Scaler to Host)
E } ]
ZXXX Zpx
E } ]
ZQQQ Zpq
E } ]
ZY Zpy
EX5& X5* X5( X6) X6!
* , , , CP
Cpn
EX5& } X5*
CP ,
Verbose modes 2 and 3:
Cpn
EX6% } X6%]
MD Pmd
E } X6%]
MD
1 = Remote port (3-pole captive screw)
4 = Universal asynchronous receiver-transmitter (UART) on TP input 4
(IN1804 DI only)
9 = UART on TP output 1A (IN1804 DO only)
300, 600, 1200, 1800, 2400, 3600, 4800, 7200, 9600 (default),
14400, 19200, 28800, 38400, 57600, 115200
Odd, Even, None (default), Mark, Space (only the first letter is required).
7 or 8 (default)
1 (default) or 2
Start point for UART ports:
TP IN4 =
TP OUT 1A =
Default = 2000
IN1804 Scaling Presentation Switcher • SIS Configuration and Control
Additional Description
Reset all device settings to factory
defaults
Set all device settings plus DHCP and
the IP address to factory defaults.
DHCP = Off, IP address =
192.168.254.254.
Same as absolute system reset except
that IP address, subnet mask, gateway
address, DHCP, and port mapping are
not reset.
}
X5& X5* X5( X6) X6!]
•Ccp , , ,
Set the RS-232 port parameters
X5( X6) X6!]
, ,
X5& X5* X5( X6) X6!]
•Ccp , , ,
View port parameters
X6!
Set the port number start point for the
over TP Universal asynchronous receiver-
transmitter (UART).
View the port number start point for the
over TP UART.
X6%
+ 1 (IN1804 DI only)
X6%
+ 3 (IN1804 DO only)
X5* X5( X6)
, ,
X5&
of port .
, and
75