Extron electronics IN1804 Series User Manual page 47

Screen Saver — Configures device behavior when no active input signal is detected.
•
Options include a black (default) or blue screen, or a user provided logo file. Optionally,
you can set a timeout to disable the output after a set duration to allow display devices
(such as a display screen or projector) to enter a lower power or standby state to
increase panel or lamp life.
To select the screen saver:
1. Select
Screen Saver

2. Press the or button to select the screen saver type. The menu selections are:

(default)
• Black
with a
• Blue No Signal
— Displays an image that has been previously uploaded to the
• User Image
IN1804. The location of this image on the screen can be adjusted using the
OSD menu (see
commands (see the
page 66) or PCS (see the IN1804 Series PCS Help File).
3. Press to confirm your selection.
Enter
NOTE: The IN1804 exits screen saver mode when the front panel
button is pressed, a video test pattern is activated, or an active input is
Enter
detected.
If the unit is in front panel lock mode (see
Modes]
on page 43), pressing a front panel button exits time out but access to
any front panel controls or the menu system is disabled.
• Screen Saver Timeout — Lets you specify the number of seconds the selected
screen saver is displayed before the output sync times out.
To set the sync timeout:
Select
• Screen Saver Timeout

Press the  or
•
out. You can select a duration of
output sync times out. Select
IN : Aspect Ratio — Sets the aspect ratio for the selected input to
•
n
output raster) or
Follow
In fill mode, if you want to set an aspect ratio adjustment for a single input rate,
•
you can select the correct image size and position manually from the
submenu (
Controls
on page 28).
In follow mode, each input rate is displayed with its native aspect ratio (4:3, 5:4,
•
16:9, or 16:10) with the correct letter box or pillar box settings, visible under the
and
Image Size Image Position
If you want a single input to fill the screen in follow mode, you can manually set
the
Image Position
to match the current output rate
Image Size
from the menu and press
Advanced
OSD message
Logo Position on the
Output
Logo Horizontal Shift and Vertical Shift commands
Front Panel Lockout [Executive
from the
Advanced
button to select the amount of time before output sync times
(timeout is immediate) to
0
(the default) to set the sync to never time out.
Never
(follows the native aspect ratio of the input).
and
Image Size Position
items on the
item on the
Picture Controls
X
IN1804 Scaling Presentation Switcher • Operation
.
Enter
submenu on page 36), SIS
or
Menu
menu and press
Enter
seconds before the
500
(fills the entire
Fill
Picture
) (see Picture Controls Submenu
submenu.
Picture Controls
submenu to , and set the
0 0
, .
Y
on
.
39