Extron electronics IN1804 Series User Manual page 20

AC Power connector — Connect a standard IEC power cord (provided) from a
A
100 to 240 VAC, 50-60 Hz power source to this connector. The front panel button
LED for the selected input (see
30 seconds. When the unit is ready for operation, the input selection LED lights steadily.
If auto-input switching has been enabled, the Auto SW LED lights also (see
Switch on the
Advanced
DisplayPort input connector (input 1) — Connect a DisplayPort source to this
B
female DP connector.
HDMI input connectors — Connect HDMI video sources to these female HDMI
C
connectors. (The standard and DO models have three HDMI input connectors while the
DI model has two.)
Use Extron HDMI LockIt Lacing Brackets to secure HDMI cables to the device
TIP:
(see HDMI Connections
Over TP IR pass-through port (IN1804 DI only) — To transmit and
D
receive IR signals, connect a control device to this 3-pole IR captive
screw connector (see the illustration at right).
NOTE: RS-232 communication can also be sent to the far end of
the twisted pair connection, but it must be done through RS-232
insertion via Ethernet. A control signal applied to an IN1804 LAN
port can be routed to the RS-232 port of any connected twisted
pair device (see Ethernet to RS-232 Insertion
DTP2/XTP input connector (input 4, IN1804 DI only) — Connect a
E
DTP2 transmitter or XTP matrix out to the DTP IN RJ-45 connector to
send and receive DTP or XTP signals over a single twisted pair cable
(see Twisted Pair Recommendations for DTP and HDBaseT Communication
page 19 for wiring and cable recommendations).
ATTENTION:
• Do not connect these connectors to a computer or telecommunications
network.
• Ne connectez pas ces ports à des données informatiques ou à un réseau de
télécommunications.
• DTP2 remote power is intended for indoor use only. No part of the network that
uses DTP2 remote power should be routed outdoors.
•
L'alimentation DTP2 à distance est destiné à une utilisation en intérieur
seulement. Aucune partie du réseau qui utilise l'alimentation DTP2 à distance
ne peut être routée en extérieur.
NOTE: Depending on the connected transmitter, the DTP2 input can travel up to
330 feet (100 meters) without loss of signal integrity.
The input 4 connector has the following LEDs:
Signal LED — Lights when the scaler is receiving an active video signal from a
•
DTP2 transmitter.
Link LED — Lights when a valid link is established to a DTP transmitter.
•
figure 14, ) on page 22) blinks for approximately
B
submenu of the OSD on page 40).
on page 18).
on page 45).
IN1804 Scaling Presentation Switcher • Installation
Auto
IR
Tx, Rx, and G
Pins
Tx Rx G
IR Device
on
12