Extron electronics IN1804 Series User Manual page 43

TP 1A Mode (IN1804 DO only) — This item lets you select the twisted pair mode of
•
the DTP2/XTP/HDBT output on the IN1804 DO. To switch among DTP, XTP, and HDBT
modes for the TP output port, select this item and press the
or .
DTP XTP
NOTE: The
Output
named
HDMI 1A Mode
TP output (1A) on the IN1804 DO.
• HDMI 1B Format — Select this option to specify an output format for HDMI output
connector 1B. Press the
• (based on the EDID of the sink) (default)
Auto
•
DVI RGB 444
•
HDMI RGB 444 Full
•
HDMI RGB 444 Ltd
•
HDMI YUV 444 Ltd
•
HDMI YUV 422 Ltd
•
HDMI YUV 420 Ltd*
*Available only for 3840x2160 and 4096x2160 resolutions
• HDCP Notification — This item lets you select what is displayed on the HDMI output
when the input signal contains HDCP-protected content and the output is a non-
HDCP sink. After pressing
between:
— Displays a green screen with the message
• Green w/OSD
HDMI output display (default).
— Displays a black screen and the output sync is maintained.
• Black Screen
— Displays a user-uploaded image. To upload images, use the PCS
• User Image
software screen (see the IN1804 Series Help File for instructions).
Logo
• User Logo — Select this item to enable or disable display of a user-uploaded logo
image. There are 16 slots available for storing logo files. To upload a logo file to the unit,
use the page of the PCS configuration program (see the IN1804 Series
Logo Config
Help File for the procedures).
To select a logo to display:
1. Select from the
Logo
2. Press the button to access the logo slots menu.
u

3. Press the or

through
01: Unassigned
Logos commands
configuration program (see the IN1804 Series Help File) to assign a logo file to the
selected slot.
When a logo is assigned to a slot, its name changes from
: . You can change this name via SIS or PCS commands.
nn Logo n
The default selection for this menu is
4. Press to confirm your selection.
Enter
NOTE: To configure logo key effects (such as RGB keying, alpha keying, and so
on) and to key logos over live video see the IN1804 Series Help File.
submenu for the IN1804 standard and DI models has an item
, which is read-only. Mode selection is available only for the

 and buttons to step through the format options.
to select this item, press the
Enter
menu and press
Output
button to select a logo slot. By default the logo slots are named
. Use the Logo SIS commands (see the
16: Unassigned
beginning on page 65) or the
.
Off
IN1804 Scaling Presentation Switcher • Operation

 or buttons to select

or button to select

HDCP Content
.
Enter
screen of the PCS
Logo Config
to
Unassigned
on the
35