Extron electronics IN1804 Series User Manual page 49

Input Switch Effect — Enables you to select the transition effect that is shown on the
•
display while the IN1804 is switching inputs (see the examples in figure 27). Press the

 or button to select from the following available effects:
3 3
Cut Through Black
4 4
Seamless Cut
Figure 27. Transition Effects
(default) — Displays a final frozen frame of the previous input while
• Seamless Fade
the newly selected input fades in (see figure 27,
— The current input fades to black before the newly selected
• Fade thru Black
input fades in ( ).
2
— The current input instantly cuts to black, then immediately cuts
• Cut thru Black
to the newly selected input with no fading in or out (
— The last frame of video freezes on the screen, then cuts to the
• Seamless Cut
newly selected input (
Factory Reset — Resets the unit to its factory default values (removing any
•
user-specified values) while retaining all TCP/IP settings.
To reset using the OSD menu, press and hold the
displayed (approximately 5 seconds). The message remains for approximately 1 minute
after the reset is complete to allow time for the display device to sync with the IN1804
output.
NOTE: The equivalent SIS command is E
For other reset methods, see
2 2
Fade Through Black
1 1
Seamless Fade
1
).
4
Enter
} .
ZXXX
Reset Modes on page 44.
IN1804 Scaling Presentation Switcher • Operation
).
).
3
button until
Factory Reset
is
41