Output Panel; Network Settings Panel (Dsc 401 A Only) - Extron electronics DSC 401 User Manual

Output Panel

The view-only Output panel (see figure 30,
refresh rate set for the output port when a device is connected. It also shows the HDCP
status of the connected output device. The following status symbols may be displayed here:
Symbol
No Device
NOTE: When connecting to a non-HDCP compliant sink, the output HDCP mode must
be set to Off to pass any video (see
DSC 401 and DSC 401 A Help File).

Network Settings Panel (DSC 401 A Only)

In the Network Settings panel (see figure 30,
address, subnet mask, and gateway address for your DSC, and turn DHCP on and off.
Figure 34.
Definition
The display is HDCP compliant.
The display is not HDCP compliant.
No device is connected.
Editing the Network Settings (DSC 401 A Only)
DSC 401 and DSC 401 A User Guide • Internal Web Page
on page 77) shows the resolution and
5
HDCP Output Mode on page 59 or the
, on page 77), you can set the IP
6
81