Assigning Parameters For Fast Mode - Siemens SIMATIC ET 200S Operating Instructions Manual

3.8.6

Assigning parameters for fast mode

Introduction
You use the following to assign parameters for the 1Count5V:
● STEP 7 Version 5.4 or higher; if necessary, the HSP (hardware support package) must
Parameter List for Fast Mode
Parameter
Response to failure of the higher-level controller
Response to CPU/Master STOP
Basic parameters
Diagnostics A and B
Diagnostics N
Signal evaluation A, B
Direction input B
Mode
Fast mode
Gate function
Input signal HW gate
Function DI
Load value
Parameter assignment error
● The "Input signal HW gate" parameter is set to inverted and the "Function DI" parameter
What to Do in the Event of Errors
Check the set value ranges.
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07
be downloaded from the Internet
Value Range
Stop operating mode
Continue operating mode
Off/on
Off/on
Rotary encoder
single/double/quadruple
Normal/inverted
Fast mode
Cancel counting/
Interrupt counting
Normal/inverted
Input /
HW gate/
Synchronization at positive edge/
HW enable for synchronization
-16777216 ... +16777215
is not set to HW gate.
3.8 Fast mode
Default
Stop operating mode
Off
Off
Rotary encoder single
Normal
Fast mode
Cancel counting
Normal
Input
0
1Count5V
203