5.4
Modes and Functions
5.4.1
Overview
Principle
The 2PULSE has two channels. You can select a separate mode for each channel.
Configuration of the operating mode is carried out using HW Config. The mode that has
been assigned parameters can then no longer be changed with your control program.
You can select from 5 different modes for each channel:
● Pulse output
● Pulse-width modulation
● Pulse train
● On/Off-delay
● Frequency output
In addition to the set mode, the 2PULSE also has the following functions:
● Measurement of current in the "Pulse width modulation" and "Pulse train" operating
● Direct control of the DO digital output by means of your control program; controllable
● Error detection/diagnostics; the 2PULSE recognizes the errors for each channel
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07
modes
separately for each channel.
separately.
2PULSE
5.4 Modes and Functions
271