Siemens SIMATIC ET 200S Operating Instructions Manual page 348

2PULSE
5.8 Technical Specifications of the 2PULSE, Terminal Assignment
General technical specifications
Data for the Digital Outputs
Output voltage

Output current


Measurement of current

Minimum pulse duration

Accuracy
Output delay (with resistive load)


Lamp load
Control of a digital input
Switching frequency
Limitation (internal) of the inductive circuit
interruption voltage
Short circuit protection for output

Cable lengths


Status, Interrupts, Diagnostics
Status indicators
Diagnostic functions


Polarity reversal can lead to the digital outputs being switched through.
1)
See the figures below
2)
With a load of ≤ 50 Ω
3)
Asymetrical edge slopes appear to be a higher percentage when switching the outputs on and
4)
off at higher frequencies
348
with "1" signal
with "1" signal
– Rated value
– Permitted Range
With "0" signal (residual current)
Accuracy
In compatibility mode
At "1" to "0" transitions
At "1" to "0" transitions
4 )
Response threshold
Unshielded
Shielded
Group error
Diagnostic information readable
Minimum L+ - 1 V
2 A (4 A at parallel connection)
2)
7 mA...2 A
max. 0.1 mA
Yes, in the "Pulse width modulation" and "Pulse
train" operating modes
3 %
100 µs
200 µs
± (period duration x 100 ppm) ±100 µs
max. 100 µs
max. 200 µs
Maximum 10 W
Yes
Up to 5 kHz
Take the technical specifications of your
connected load into consideration.
L+ -(50 V ... 65 V)
Yes
Typ. 10 A to 16 A
600 m
1000 m
Green LED for DI 0, DI 1, DO 0, DO 1
Red LED "SF"
Yes
Operating Instructions, 06/2010, A5E00124867-07
3)
Technological Functions