Siemens SIMATIC ET 200S Operating Instructions Manual page 192

1Count5V
3.7 Measurement Modes
Access to the Control and Feedback Interface in STEP 7 Programming
Table 3- 19 Access to the Control and Feedback Interface in STEP 7 Programming
Feedback interface
Control interface
Load and transfer commands are also possible with CPU 3xxC, CPU 3xx with MMC, and CPU 4xx (V3.0 and later).
1
Resetting of the Status Bits
STS_CMP1, STS_OFLW, STS_UFLW
Figure 3-31
192
Configuring with STEP 7
using the GSD file )
1
(Hardware catalog\PROFIBUS-DP\Additional
FIELD DEVICES\I/O\ET 200S)
Read with SFC 14 "DPRD_DAT"
Write with SFC 15 "DPWR_DAT"
Resetting of the Status Bits
Configuring with STEP 7
using HW Config
(Hardware catalog\PROFIBUS-
DP\ET 200S)
Load command (e.g. L PID)
Transfer command, e.g. T PQD
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07