Technical Specifications For Programming, Reference Lists - Siemens SIMATIC ET 200S Operating Instructions Manual

5.9

Technical Specifications for Programming, Reference Lists

Assignment of the short control interface (8 bytes)
Address
Channel 0 Channel 1
Word 0 Word 4
Byte 2 Byte 6
Byte 3 Byte 7
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07
5.9 Technical Specifications for Programming, Reference Lists
Assignment
Depending on the mode
Pulse output: Pulse duration

Pulse width modulation: Output value

Pulse train: Number of pulses

On/Off-delay: Off-delay

Frequency output: Output frequency

Bit 7: Reserve = 0
Bit 6: Reserve = 0
Bit 5: Reserve = 0
Bit 4: Reserve = 0
Bit 3: Reserve = 0
Bit 2: SET_DO
Bit 1: MANUAL_DO
Bit 0: SW_ENABLE
Depending on the mode
Pulse output: On-delay factor

Pulse-width modulation: Period duration factor

Pulse train: Period duration factor

On/Off-delay: On-delay factor

Frequency output: On-delay factor

2PULSE
353