Siemens SIMATIC ET 200S Operating Instructions Manual page 174

1Count5V
3.7 Measurement Modes
Function of the Digital Output DO1
For the "Function DO1" parameter, select one of the following functions for the DO1 digital
output:
● Output (no switching by the limit-value monitoring)
● Measured value outside the limits
● Measured value under the low limit
● Measured value over the high limit
(see section "Behavior of the Outputs in Measurement Modes (Page 186)")
Function of the Digital Output DO2
● Output
(see section "Behavior of the Outputs in Measurement Modes (Page 186)")
Changing Values during Operation
The following values can be changed during operation:
● Low limit (LOAD_PREPARE)
● High limit (LOAD_VAL)
● Function of the Digital Output DO1 (C_DOPARAM)
● Integration time/update time (C_INTTIME)
(see sections "Behavior of the Outputs in Measurement Modes (Page 186)" and
"Assignment of the Feedback and Control Interfaces for the Measurement Modes
(Page 188)")
174
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07