Example: Starting 2Pulse - Siemens SIMATIC ET 200S Operating Instructions Manual

2PULSE

5.3 Example: Starting 2PULSE

5.3 Example: Starting 2PULSE
Task
These brief instructions guide you to a functioning application that will enable you to become
familiar and check the basic hardware and software functions of your 2PULSE. The "Pulse
output" mode is used as an example here. Channel 0 of the 2PULSE is used in the example.
Requirements
The following requirements must be satisfied:
● You must have put an ET 200S station on an S7 station with a DP master into operation.
● You must have the following:
Installation and Fitting
1. Install the TM-E15S24-01 terminal module (see the figure below).
2. Plug the 2PULSE into the terminal module. Detailed instructions are provided in the
268
– An interface module IM151-1 (as of order number 6ES7 151-1AA04-0AB0) or
IM151-1 HIGH FEATURE (as of order number 6ES7 151-1BA02-0AB0) or
IM151-8 PN/DP CPU (as of order number 6ES7 151-8AB00-0AB0) or
IM151-7 CPU (as of order number 6ES7 151-7AA20-0AB0)
– A terminal module TM-E15S24-01 or TM-E15x26-A1
(order number 6ES7 193-4CBx0-0AA0 or 6ES7 193-4CAx0-0AA0)
– A "2 PULSE"
(order number 6ES7 138-4DD01-0AB0).
ET 200S Distributed I/O Device
(http://support.automation.siemens.com/WW/view/en/1144348) operating instructions.
It is not necessary to wire the 2PULSE for this example.
Figure 5-1 Terminal assignment of the 2PULSE for the example
Technological Functions
Operating Instructions, 06/2010, A5E00124867-07